прорешалась 2х фазная задача (стальная частица летит в газовом потоке, разогревается до температуры 800С и разгоняется до 600м/с ) ... визуализтирую particle track и на тебе, трэки обрываются не доходя до окончания домена.. чего это вдруг...?!
http://www.arc.vt.edu/ansys_help/cfx_solv/output_file_particle_runs.html
Exceeded Integration Limit
This message indicates that these particles have exceeded the maximum number of integration steps with respect to the total number of particle integration steps. If a large number of particles show this fate, you may need to increase the maximum number of integration steps. For details, see Maximum Number of Integration Steps. Any remaining mass, momentum, and energy that must be exchanged with the fluid to equilibrate the aborted particle with the local fluid properties, is exchanged in the current control volume.
лечится след образом
http://www.arc.vt.edu/ansys_help/cfx_mod/cfxPartPart2.html#i1339993
Maximum Number of Integration StepsThis is another control that can be used to terminate tracking of particles that may become trapped in recirculation zones. The number of integration steps is calculated as the number of integration steps per element multiplied by the number of elements crossed by a particle. The default value is 10,000. You can increase this number if you believe it will be exceeded by a particle following a normal route through the simulation.
привет! прости, был в отпуске. количество шагов интегрирования действительно помогает, но у тебя-то прямой канал вроде, там оно не должно превышать дефолтного значения.
Привет!
Что-то не видно ни фига на картинке. В out файл что пишется по поводу вошло/вышло?
privet
v prilozhenii out
http://www.cae-club.ru/files/out
в большинстве случаев происходит вот по этому
http://www.arc.vt.edu/ansys_help/cfx_solv/output_file_particle_runs.html
Exceeded Integration Limit
This message indicates that these particles have exceeded the maximum number of integration steps with respect to the total number of particle integration steps. If a large number of particles show this fate, you may need to increase the maximum number of integration steps. For details, see Maximum Number of Integration Steps . Any remaining mass, momentum, and energy that must be exchanged with the fluid to equilibrate the aborted particle with the local fluid properties, is exchanged in the current control volume.
лечится след образом
http://www.arc.vt.edu/ansys_help/cfx_mod/cfxPartPart2.html#i1339993
Maximum Number of Integration StepsThis is another control that can be used to terminate tracking of particles that may become trapped in recirculation zones. The number of integration steps is calculated as the number of integration steps per element multiplied by the number of elements crossed by a particle. The default value is 10,000. You can increase this number if you believe it will be exceeded by a particle following a normal route through the simulation.
привет! прости, был в отпуске. количество шагов интегрирования действительно помогает, но у тебя-то прямой канал вроде, там оно не должно превышать дефолтного значения.
чез слово не знаю почему так получилось - подкрутил... теперь сколько вошло, столько и вышло :)
шаман
Добавить комментарий